Perle CM-1000-S1SC20U - Fiber media converter - GigE - 1000Base-T, 1000Base-BX-U - RJ-45 / SC single-mode - up to 12.4 miles - 1310 (TX) / 1490 (RX) nm

Perle CM-1000-S1SC20U - Fiber media converter - GigE - 1000Base-T, 1000Base-BX-U - RJ-45 / SC single-mode - up to 12.4 miles - 1310 (TX) / 1490 (RX) nm
1 / 1

Description

    • Pause. Pause signaling is an IEEE feature that temporarily suspends data transmission between two devices in the event that one of the devices becomes overwhelmed. The media converter supports pause negotiation on the 1000 Base-T fiber connection.
    • Smart link pass-through. This feature can be used whether fiber auto-negotiation is enabled or disabled.
    • Low power mode. If enabled it sets the gigabit copper transceiver into "low power mode" which limits the strength of the signal.
    • Auto-negotiation. The media converter supports auto negotiation. The 1000 Base-T negotiates according to 802.3 clause 28 and 40. The media converter supports auto-negotiation of full duplex, half duplex, remote fault, full duplex pause, asymmetric pause and auto MDI-X.
    • Configuration mode selection. Select whether the module is to use the on-board DIP switches or enable the management module in the chassis to manage.
    • Auto-MDIX with skew correction. Auto-MDIX detects the signaling on the 1000 Base-T interface to determine the type of cable connected and automatically configures the connection when enabled. The media converter can also correct for wires swapped within a pair.
    • Backup and restore. Provides fast and easy module replacement. Management module will always save a copy of the media converter configuration and will restore this configuration automatically to the media module when it is detected in the slot.